Power cable problem. Need a replacement

Repair forum for T.V's and Monitors only.

Power cable problem. Need a replacement

Postby blkapache » Sat Jun 03, 2017 4:42 pm

Hey folks,

I have an issue with a flat panel tv. There was a lot of humming noise when I turned it on and it just eventually shut down all together. Turned on for about 10 seconds...then shut off. Turned on again, shut off less than 5 seconds. Now, it won't turn on at all. I opened the back and found this set of cables to the power supply fried. The supply itself is good but as you can see, the connector is toast. Does anyone know where I get another set of these from? It's for a Visco tv and VSC-32V1 is the model number. I already tried shopjimmy.com but I haven't had any success. Thanks.
Image

Image
blkapache
VIP Member
VIP Member
 
Posts: 283
Joined: Mon Apr 08, 2013 3:03 pm
Location: Alabama, United States
National Flag:
United States of America
Has thanked: 66 times
Been thanked: 25 times
Set up: Achi IR PRO SC, JBC CD-1BB soldering station, W.E.P. 858D hot air wand station.

Power cable problem. Need a replacement

Sponsor

Sponsor
 

Re: Power cable problem. Need a replacement

Postby matic_s » Sun Jun 04, 2017 8:14 am

Hello!

I think it would be hard to find the new set of cables.

I already had such case in one TV. I cut off the toasted connector and solder wires directly to the board.
User avatar
matic_s
VIP Member
VIP Member
 
Posts: 484
Joined: Mon Mar 09, 2015 9:14 pm
Location: Slovenia, EU
National Flag:
Slovenia
Has thanked: 26 times
Been thanked: 82 times
Set up: Achi IR PRO SC V3, Atten 850B, Hameg HM507

Re: Power cable problem. Need a replacement

Postby blkapache » Mon Jun 05, 2017 12:13 am

matic_s wrote:Hello!

I think it would be hard to find the new set of cables.

I already had such case in one TV. I cut off the toasted connector and solder wires directly to the board.


Thanks, matic. I didn't even consider that. Thanks.
blkapache
VIP Member
VIP Member
 
Posts: 283
Joined: Mon Apr 08, 2013 3:03 pm
Location: Alabama, United States
National Flag:
United States of America
Has thanked: 66 times
Been thanked: 25 times
Set up: Achi IR PRO SC, JBC CD-1BB soldering station, W.E.P. 858D hot air wand station.


Return to T.V's and Monitors

Who is online

Users browsing this forum: No registered users and 1 guest