Having trouble Identifying Burnt SMD component

Section for repairs of all other electrical items without their own section.

Having trouble Identifying Burnt SMD component

Postby neverexisted » Thu Aug 24, 2017 8:37 pm

Hello. I have a motherboard I am attempting to repair for a customer. I found a burnt transistor/voltage regulator? But I can only make out the first two or 3 markings on it.

How would I go about finding it based off the markings or half the markings in my case.


https://postimg.org/gallery/121wne7y8/

Thanks for reading this
neverexisted
Elite Member
Elite Member
Progress to next rank:
0%
 
Posts: 70
Joined: Fri Dec 21, 2012 8:36 pm
Has thanked: 1 time
Been thanked: 2 times
Set up: ACHI IR SC PRO - 500W Bottom Plates - Dual Lamps - Omega TC's

Having trouble Identifying Burnt SMD component

Sponsor

Sponsor
 

Re: Having trouble Identifying Burnt SMD component

Postby matic_s » Tue Aug 29, 2017 11:27 am

It is transistor, but schematic for this revision of the board is not available (for now).

Remove burned component, clean the board and post clear picture of pads on the board.

Which markings are visible on burned component?
User avatar
matic_s
VIP Member
VIP Member
 
Posts: 484
Joined: Mon Mar 09, 2015 9:14 pm
Location: Slovenia, EU
National Flag:
Slovenia
Has thanked: 26 times
Been thanked: 82 times
Set up: Achi IR PRO SC V3, Atten 850B, Hameg HM507


Return to Other Repairs

Who is online

Users browsing this forum: No registered users and 2 guests