DIY Preheater (need advise)

Forum for all DIY topics.

DIY Preheater (need advise)

Postby blackoutfolo » Fri Oct 16, 2015 12:09 pm

Hello everyone,

I would like to make a preheated station much like the Puhui T8280. It is essentially for components such mosfet tansistor etc. Not for BGA rework. I already have a station for Bga.
Before I would like to know if all these items are sufficient:

1- Digital PID Temperature Controller REX-C100 Thermostat + Max.40DA SSR Relay K Thermocouple Probe +

2- 2 or 3x 450W ceramic heating plate 80 * 80mm

3-May be 2x another Max.40DA SSR Relay

Am I right? do I need anything else?
Can Rex c-100 controller 3x ceramic heating plate?
Do I need 3 x Max.40DA SSR Relay or one is enough?

Sorry for my english
blackoutfolo
New Member
New Member
Progress to next rank:
20%
 
Posts: 1
Joined: Fri Nov 15, 2013 9:11 am
Location: Togo
Has thanked: 0 time
Been thanked: 0 time
Set up: Not yet / Plain to buy new rework station

DIY Preheater (need advise)

Sponsor

Sponsor
 

Re: DIY Preheater (need advise)

Postby Jane11 » Sat Oct 17, 2015 6:44 pm

REX-C100 Thermostat will not allow you to set up profiles.
I think you need Altec
Jane11
Valued Member
Valued Member
Progress to next rank:
70%
 
Posts: 37
Joined: Tue Mar 11, 2014 5:52 pm
Location: Honolulu
Has thanked: 0 time
Been thanked: 1 time

DIY Preheater (need advise)

Postby dream_coder » Fri Oct 23, 2015 4:47 pm

You do not need steps in a profile for a pre-heater... what you suggested is fine, just ensure you have the correct cables for wiring such as npc cable for the heaters and suitable cable for the rest.

Not sure why you would need 3 SSRS you only need one


Sent from my iPhone using Tapatalk
dream_coder
VIP Member
VIP Member
 
Posts: 157
Joined: Wed Feb 06, 2013 5:53 pm
Location: N East UK
Has thanked: 20 times
Been thanked: 13 times
Set up: Scotle IR PRO SC / IR360 Pro V3


Return to DIY Forum

Who is online

Users browsing this forum: No registered users and 1 guest