BGA Clean Up "Jig"

Place your before and after pictures here and any repair tips you may have .Remember no Rgh/Jtag work.

BGA Clean Up "Jig"

Postby jamesfreddie » Sun Apr 07, 2013 1:02 pm

Image

I am sorry for the bad image quality.

Its quite self explanatory but it basically cardboard tapped together with kapton tape holding all the parts together with a square hole in the middle for the chip.

This makes cleaning a BGA much easier than cleaning it in the scotle jig as it doesn't jump out when cleaning it with the braid.

Also the kapton tape is heat resistive so it doesn't matter if you brush it with your soldering iron.
jamesfreddie
Banned
Banned
 
Posts: 914
Joined: Thu Nov 08, 2012 6:28 pm
Location: Waltham Abbey, Essex, England
National Flag:
Great Britain
Has thanked: 58 times
Been thanked: 115 times
Set up: Honton R392 Atten 858D, Aoyue 968, T8280, SCOTLE HT-80, WEP 942 Aoyue 2901 Clone

BGA Clean Up "Jig"

Sponsor

Sponsor
 

Return to Showcase Your Repairs, Tips & Tricks

Who is online

Users browsing this forum: No registered users and 1 guest