wanting to make a arduino reflow controller for my aoyue 968

Anything you're looking for post in here.

wanting to make a arduino reflow controller for my aoyue 968

Postby htsauce » Mon Oct 06, 2014 9:38 pm

wanting to make a arduino reflow controller for my aoyue 968a+ rework station & aoyue 853a preheater
i have a udoo board (arduino due footprint )
any ways ive been finding a lot of tutorials of a diy reflow oven with an arduino kit to control it for you
im guessing my inquiry is,

could i use one of these kits, to run a some what unattended reflow?
im assuming where they connect to the heat control nob for adjustments , i could potentially connect to my 968a in a similar fashion, to control the output temp of the heat nozzle according to the exact temp on the sensors , but maintain the rise/drop ratio, ?
i would assume its an analog connection to the heat control in the toaster oven ,

(if so im looking to mod my solder station with a connector or incorporate it to the chassis of the solder station)


im wondering if anyone has done this or is also in process of doing this, it would be awesome to get a more accurate reflow
htsauce
New Member
New Member
Progress to next rank:
20%
 
Posts: 1
Joined: Mon Oct 06, 2014 8:42 pm
Location: auburn ca
Has thanked: 0 time
Been thanked: 0 time
Set up: aoyue int 968a+, & aoyue int 853a & stand,

wanting to make a arduino reflow controller for my aoyue 968

Sponsor

Sponsor
 

Return to Wanted

Who is online

Users browsing this forum: No registered users and 1 guest

cron